Silverton 610 would not ignite, now no display.

Qballgeg

New member
Joined
Jun 28, 2020
Messages
11
Media
1
Reaction score
8
Location
Hilton Head
Grill
What to buy
Booted up the 610 to do some smoking today…hit ‘ignite’, and after about 5 minutes I get an error message to restart. Shut everything down, unplugged, plugged back in and now I get no display. Anyone had this issue?
 
If it has a D2 controller, I'd try flipping the red power switch Off, wait 20 sec, then On. Maybe a couple of times, until you see the controller's power button light up. Then press the button.

My Timberline did this once, like the power brick glitched but eventually reset.
 
Check to make sure the Traeger power cord is plugged in and fully seated to the underside of the pellet hopper box connection point. My Silverton 810 went off line intermittently and later had no power. I suspect the Traeger power cord was loose at the underside of the hopper box during the intermittent issues and we found the cord completely separated when no power was available later. After reseating the cord end no problems.
 

Latest Discussions

Back
Top