davwhite
Well-known member
Good idea, because I am getting a difference of 20F between the Traeger and the Fireboard.
Permanent Probe Location
- Thread starter Slimpicker
- Start date
Sloppysalmon219
Active member
I just got my fireboard 2 and the spark is being delivered Friday and want to mount a permanent probe in my pro 575 aswell.. what locations did everyone decide on
davwhite
Well-known member
It is an extra order (the nuts)
Sloppysalmon219
Active member
On the pit do u have it installed yet
davwhite
Well-known member
I have a 575 and if you have one ambient probe and it is the threaded type then mount it as close as possible to the Traeger one. To open the hopper I have to bend the flexible part just a bit. If you want it closer to the original then you will have to drill through the hopper box and use a grommet to stop pellets falling out.
Attachments
Sloppysalmon219
Active member
Thanks
OP
OP
So I think that's a 3/4 (or whatever the size hole is in your Traeger) hole that the probe rubber grommet fits into... you would drill this hole threw your hopper, then drill for the probe in the pit wall, install the probe, run the wire between the pit and the hopper, plug the hopper hole with a NEW probe grommet and DO NOT puncture the grommet which is solid until you do... this will stop the pellets.
I'm planning on doing this in the spring... for the next 2 months it's "knee replacement" for me... I'll be laying low for a while.
JPSBBQ
Well-known member
Earned himself a ban for too many warnings
It’s a device issued to sad people who could never make it on their own two feet without it.
OP
OP
^^^^^^^^^^^^^^^^ That's what a troll filter is ^^^^^^^^^^^^^^^^^^^^
Traeger Photos
Traeger Photos
