kwiebe
New member
On second use, set to 200. Temp got to 130, then stalled. Waited 15 minutes as temp gradually dropped all the down to 80. Auger was working during this time, I could hear it.
Shut down, cleaned fire pit, re-ran the priming procedure. Re-ignited.
This time, got up to 150 then did essentially the same thing.
So this time I bumped the temp setting up to 400 - it actually got there pretty normally. Then I set it down to 200 where I wanted it. It seemed to stay within 15 plus or minus.
Why would I have to go way past a low temperature, initially?
Shut down, cleaned fire pit, re-ran the priming procedure. Re-ignited.
This time, got up to 150 then did essentially the same thing.
So this time I bumped the temp setting up to 400 - it actually got there pretty normally. Then I set it down to 200 where I wanted it. It seemed to stay within 15 plus or minus.
Why would I have to go way past a low temperature, initially?